Correct Handling of Unexpected Stop of Fully Automatic Molding Machine

1. First of all, the demand of automatic molding machine for sand (core) property
1. Strength: External force is not easy to damage performance, but insufficient strength will lead to crash box, trachoma;
2. Air permeability: The gap between the sand itself has air permeability. If the air permeability is not good, it is easy to produce pores;
3. Fire resistance: it will not soften insufficiently under hot liquid metal. Most molding machine manufacturers have done material fire resistance tests. If refractory, the molding sand is bonded to the surface layer of the shell, resulting in severe difficulty in cutting, sand sticking, and casting waste;
Second, secondly, the benefits of clay, sand casting, from the influence of the size, weight, size, and volume of the casting;
1, cast iron, steel, copper can be;
2. Molding machine manufacturers can choose hand-made or machine-made.
3. Widely sourced from clay, cheap and recyclable
Manufacturers can require a low level of this series of fully automatic molding machines, fully automatic molding machines, sand molds, dry sand molds and wet sands, with good initial viscosity and general viscosity problems. Red sand, black sand beach, and sand coal can be used.
Copper is commonly used in red sand castings, iron castings and steel castings, usually black sand.
automatic molding machine
Third, molding machine manufacturers deal with unplanned downtime:
1. Stop after work
Employees of injection molding machine manufacturers often need to leave their jobs after hours, and you need to stop work. In this case, production personnel should check the molding machine so that there is no material debris in the equipment. Therefore, one can keep the machine clean by cleaning.
2. Temporary shutdown
stop. stop. Refers to the failure of the molding machine or the person leaving the molding machine, causing the molding machine to stop running. If there is an obstruction, shutting down the power requires a normal inspection, cleaning the machine so that it can work properly. If the person leaves the machine, just hit the pause switch and keep production going.
3. Long-term downtime
If the molding machine is not in production, it needs to be shut down for a long time. Entering this state is convenient for people to clean. Power should be turned off to reduce power effects. Additionally, the valves in the equipment need to be closed to maintain good performance. In addition, one needs to clean the materials and lubricants in the equipment.