Two Shortcuts to Extend the Life of Fully Automatic Molding Machines

Two Shortcuts to Extend the Life of Fully Automatic Molding Machines
①Reduce all kinds of corrosion
Fully automatic molding machine manufacturers call the chemical or electrochemical damage phenomenon on the metal surface called corrosion. This kind of corrosion will not only affect the normal operation of the mechanical appearance equipment, but also corrode the internal parts of the machine. like in the rain, in the air
Learn that substances and other components enter the machine through the external passages and gaps of mechanical parts, corrode the internal parts of the machine, accelerate mechanical wear, and increase mechanical failure. Because this corrosion is sometimes invisible, unseen and easily overlooked. And more dangerous. In use, managers and operators should take effective measures to reduce the impact of chemical corrosion on machinery according to local weather conditions and air pollution. Chemical composition against rain and air from mechanical intrusion.

②Guaranteed normal workload
Automatic assembly equipment suppliers say the size and nature of construction machinery workloads have a significant impact on the mechanical wear process. Generally speaking, the wear of parts increases proportionally with the increase in load. Wear increases when the part is loaded above the average design load. In addition, when other conditions are the same, the stable load is smaller than the dynamic load, the failure is less, and the life is shorter. The test shows that under the action of unstable load, the wear of the cylinder increases by 2 times than that under the steady load. Under normal load, the engine failure rate is low and the life is long. On the contrary, the failure rate of the heavy-duty engine increases significantly, and the life is also lower than the design index. The amount of mechanical wear that often varies over a wide load range is greater than that of a continuously stable machine.
Definition of fully automated:
It is composed of mechanical, electrical, hydraulic, pneumatic, optical, acoustic, visual imaging, program control technology and sensing technology.
Most countries do not have uniform standards and norms. According to the special requirements of the product, according to the requirements and technical requirements of the product itself, the product design and manufacture are carried out. There are currently no applicable standards. Design and manufacture according to their respective needs. Appearance or performance not in the National Equipment Catalog. Widely used in various industrial fields.